CSQP sample questions

Question 1

When developing a process for supplier selection and qualification, a Supplier Quality Engineer needs to identify and map the influence of sub-tier suppliers on the final product. Which of the following tools provides a high-level visual representation of the process from the sub-tier supplier's raw material to the final customer delivery?

Accepted Answer

SIPOC

Answer

Total Risk Factor Analysis

Answer

Value Stream Map

Answer

Kraljic Matrix

Question 2

The 2023 CSQP Body of Knowledge distinguishes between Supplier Agreements and Quality Agreements. Which TWO of the following elements are primarily found in a Quality Agreement rather than a general Supplier Agreement? (Select TWO)

Accepted Answer

Out-of-specification (OOS) investigation protocols

Accepted Answer

Change control notification requirements

Answer

Payment terms and invoicing schedules

Answer

Intellectual property ownership rights

Answer

Indemnification and liability limits

Question 3

During the development of a supplier performance monitoring system, a procurement team defines the criteria under which the organization will terminate its relationship with an underperforming supplier and transition to an alternate source. This criteria is formally known as a(n):

Accepted Answer

Exit Strategy

Answer

Disqualification Protocol

Answer

Contingency Plan

Answer

Risk Mitigation Plan

Question 4

A manufacturing firm is undertaking a supply chain rationalization initiative to optimize its supply base. The team discovers that 80% of their annual spend is distributed among just 15% of their suppliers, while the remaining 20% of spend is spread across 85% of their suppliers.

Which of the following actions is the MOST appropriate strategy to leverage investments into supplier quality based on this data?

Accepted Answer

Consolidate the low-spend suppliers to reduce administrative overhead and focus quality investments on the high-spend strategic partners.

Answer

Equally distribute quality audit resources across all suppliers to ensure baseline compliance.

Answer

Shift 50% of the spend from the top suppliers to the bottom suppliers to balance the risk portfolio.

Answer

Immediately disqualify the bottom 85% of suppliers and source all materials from the top 15%.

Question 5

In a standard supplier classification system, a 'Preferred' supplier typically has demonstrated higher sustained performance levels and deeper strategic alignment than an 'Approved' supplier.

Accepted Answer

True

Answer

False

Question 6

A critical electronic component for a life-saving medical device is sourced from a single supplier. The supplier recently experienced a catastrophic failure in their cleanroom HVAC system, halting production for three weeks. To assess and prioritize the risks of similar future failures across the entire system, the quality team needs a top-down analytical tool that starts with the undesired event (production halt) and maps out all possible logical combinations of subsystem failures that could cause it.

Which of the following risk analysis tools is BEST suited for this specific requirement?

Accepted Answer

Fault Tree Analysis (FTA)

Answer

Process Auditing

Answer

Failure Mode and Effects Analysis (FMEA)

Answer

Decision Analysis (DA)

Free CSQP sample questions

The 2023 CSQP Body of Knowledge distinguishes between Supplier Agreements and Quality Agreements. Which TWO of the following elements are primarily found in a Quality Agreement rather than a general Supplier Agreement? (Select TWO)

During the development of a supplier performance monitoring system, a procurement team defines the criteria under which the organization will terminate its relationship with an underperforming supplier and transition to an alternate source. This criteria is formally known as a(n):

In a standard supplier classification system, a 'Preferred' supplier typically has demonstrated higher sustained performance levels and deeper strategic alignment than an 'Approved' supplier.

6 more free samples are waiting