3V0-25.25 sample questions

Question 1

An administrator is preparing to deploy a multi-site VCF 9.0 solution using NSX Federation. The design calls for a primary site in New York and a secondary site in London. Regarding the deployment of the Global Manager (GM), which statement correctly describes the required procedure?

Accepted Answer

The Global Manager must be deployed manually using the NSX OVF/OVA on vCenter before configuring Federation in SDDC Manager.

Answer

The Global Manager is a role enabled on the existing Local Manager of the primary site; no new appliance is needed.

Answer

The Global Manager must be deployed automatically via the SDDC Manager UI as part of the Multi-Site workflow.

Answer

The Global Manager is deployed via VCF Cloud Builder during the initial bring-up of the secondary site.

Question 2

A DevOps team requires a self-service networking environment where they can create their own subnets, define firewall rules, and configure load balancing without submitting tickets to the central IT team. The environment must be isolated but able to route traffic to other internal services. Which VCF 9.0 construct should the administrator provision for this team?

Accepted Answer

NSX Project with a Virtual Private Cloud (VPC)

Answer

A Standalone Tier-1 Gateway connected to a physical firewall

Answer

An isolated Overlay Transport Zone

Answer

A dedicated Tier-0 Gateway with VRF-Lite

Question 3

While troubleshooting a North-South connectivity issue for a specific tenant in a multi-tenant VCF environment, an administrator needs to determine if the packet is being dropped at the Distributed Router (DR) or the Service Router (SR) component of the Tier-1 Gateway.

Which tool should the administrator use to inject a synthetic packet and visualize the hop-by-hop path through the logical routers?

Accepted Answer

NSX Traceflow

Answer

IPFIX Collector

Answer

NSX Port Mirroring

Answer

Live Traffic Analysis

Question 4

A network architect is designing the upstream physical connectivity for an NSX Edge Cluster that will support high-bandwidth ECMP routing. The design requires that if a single Edge node fails, traffic should failover in less than one second. Which protocol must be configured between the Tier-0 Gateway and the physical routers to meet this requirement?

Accepted Answer

BGP with Bidirectional Forwarding Detection (BFD)

Answer

OSPF with Fast Hellos

Answer

LACP with Fast Rate

Answer

VRRP with sub-second timers

Question 5

An administrator is configuring a Tier-0 Gateway in a VCF 9.0 environment. The requirement is to maximize North-South throughput by utilizing all available paths across 4 Edge Nodes. Which High Availability (HA) mode must be selected to support Equal Cost Multi-Path (ECMP) routing?

Accepted Answer

Active-Active

Answer

Active-Standby

Answer

Preemptive Failover

Answer

Non-Preemptive Failover

Question 6

A VCF architect is planning a deployment for a small remote branch office with limited hardware resources. The site requires full NSX functionality but has a constraint on the management footprint. Which VCF 9.0 supported deployment option should be chosen to minimize resource usage while maintaining functionality?

Accepted Answer

Deploy a single NSX Manager node

Answer

Deploy NSX Manager with 2 vCPUs

Answer

Deploy NSX Manager on the Edge Nodes

Answer

Utilize NSX Cloud service

Free 3V0-25.25 sample questions

An administrator is preparing to deploy a multi-site VCF 9.0 solution using NSX Federation. The design calls for a primary site in New York and a secondary site in London. Regarding the deployment of the Global Manager (GM), which statement correctly describes the required procedure?

An administrator is configuring a Tier-0 Gateway in a VCF 9.0 environment. The requirement is to maximize North-South throughput by utilizing all available paths across 4 Edge Nodes. Which High Availability (HA) mode must be selected to support Equal Cost Multi-Path (ECMP) routing?

6 more free samples are waiting